Jan. 21, 2020
Today, the Fluorescent Brightener Agent Manufacturer will introduce the precautions for using fluorescent whitening agents.
1. Whitening effect of fluorescent whitening agent
The whitening effect is often expressed by whiteness. In addition to the amount of fluorescent whitening agent added, it is also related to the compatibility of the resin and the light resistance of the plastic. The fluorescent whitening agent with good compatibility and good light resistance has good whitening effect and lasting. The most direct and effective way to verify the whitening effect of fluorescent brighteners is to conduct a sample experiment.
2. Dosage of fluorescent whitening agent
The amount of Fluorescent Brightener Agent is usually expressed as a percentage relative to the mass of the plastic. The amount of fluorescent whitening agent in plastic is related to its chemical structure, dispersion, and the properties of plasticizers or other additives in plastic formulations. The amount of fluorescent whitening agent is generally 0.05% to 0.1% (for plastic), for ultra-white varieties, the amount can reach 0.5% (for plastic) or more; for transparent plastic, the amount is 1% of the above amount. / 100 ~ 1/10. Appropriate dosage should be determined by sample test to meet the requirements of application. It is not that the more the amount of fluorescent whitening agent used, the better the whitening effect, but there is a certain concentration limit that exceeds a certain limit value. , Not only does not have a whitening effect, and even yellowing occurs. Excessive amount of fluorescent whitening agent will also cause incompatibility, migration phenomenon, and degradation of anti-aging performance.
Using two or more different fluorescent whitening agents, if selected properly, the fluorescence spectrum will be broadened, and its fluorescence intensity will be enhanced to achieve the purpose of efficiency enhancement, while improving its application performance.
Optical Brightener Agent For Plastic
3.Effect of pigments in plastic formula on whitening effect of Optical Brightener Agent For Plastic
Since the role of the fluorescent whitening agent is to convert ultraviolet light into visible blue or purple light, the components that have the greatest impact on the fluorescent whitening agent itself are those that can absorb ultraviolet light, that is, white pigments and ultraviolet light stabilizers. Titanium dioxide in white pigments can absorb the 380nm light wave in ultraviolet light. If it is present in plastic products, it will reduce the whitening effect of fluorescent whitening agents. Due to the different absorption of 380nm light waves of different crystal types of titanium dioxide, the anatase type can only absorb 40% of 380nm light; the rutile type can absorb 90%. If titanium dioxide is used in combination with a fluorescent brightener, anatase should be used Type titanium dioxide and appropriately increase the amount of fluorescent whitening agent.
White pigments vary according to how much they absorb ultraviolet light. The ultraviolet light in the area that works for most fluorescent brighteners is also absorbed by the anatase and rutile titanium dioxide. The zinc sulfate has a slightly lower absorption capacity for this part of the ultraviolet light. This difference is most pronounced in molded articles colored with white pigments containing fluorescent brighteners. At the same concentration of fluorescent whitening agent, generally speaking, the whitest color is the strongest when zinc sulfate is used, and the whitest color is the weakest when rutile titanium dioxide is used. Under certain conditions, the use of rutile pigments cannot significantly increase the degree of whiteness. If you need to increase the whiteness, you should increase the concentration of fluorescent whitening agent. For example, in the polyethylene formula, use 2.0% rutile pigment and 0.2% fluorescent whitening agent, or use 5% anatase pigment and 0.05 % Fluorescent whitening agent, you can get white effect immediately.